the resistance method

Using carbon material in manufacturing process of VRLA battery

Mar , 02 2022

Several types of carbon find various uses in many types of electrochemical power sources. In this article, we focus on implementations of its elemental forms in presently used lead-acid batteries, as well as potential future improvements to their construction that carbon can bring. Unique properties of carbon and a variety of its allotropes allow it to find a use in different parts of lead-acid ba...

more

What types of monitoring and recording devices are suited for high rate charging?

Jun , 20 2022

The higher the charging rate, the more critical it is to monitor the charging process to prevent permanent capacity loss. In efforts to preserve battery life, Fast and Opportunity charging incorporates a method of monitoring battery electrolyte temperature and/or internal resistance and adjusting charging current as necessary. Although these monitoring devices can have a very positive impact on ba...

more

What are the reliability and safety test items for batteries?

Oct , 17 2022

What are the reliability test items for batteries? 01) Cycle life 02) Discharge characteristics at different rates 03) Discharge characteristics at different temperatures 04) Charging characteristics 05) Self-discharge characteristics 06) Storage characteristics 07) Overdischarge characteristics 08) Internal resistance characteristics at different temperatures 09) Temperature cycle test 10) Drop t...

more

Charge and discharge theory and calculation method design of lithium battery

May , 13 2023

1 . Production of lithium Ion battery 1 .1 State Of Charge ( state-of-charge; S OC) Soc can be defined as the state of available electrical energy in the battery, usually expressed as a percentage. Because the available electric energy varies with charging and discharging current, temperature, and aging phenomenon, the definition Of the State of Charge is also divided into two types: Absolute stat...

more

Important performance of the battery

Sep , 04 2023

1, electrical performance: (1) Rated capacity: 0.5C discharge, single battery discharge time is not less than 2h, battery pack discharge time is not less than 108min (95%); (2) 1C discharge capacity: 1C discharge, single battery discharge time is not less than 57min (95%), battery pack discharge time is not less than 54min (90%); (3) Low temperature discharge capacity: 0.5C discharge at -20℃, the ...

more

Interface level standards between digital systems

Sep , 09 2023

Preface When we constrain the FPGA project, we often see such level standards, such as LVCOM18, LVCOS25, LVDS, LVDS25, etc. In fact, these are a series of level standards, in order to have a deeper understanding of the level standards, the following excerpts from the book "The FPGA Way" for the explanation of the level standards to understand. Dual Threshold Standard The so-called dual-threshold s...

more

The working principle and control method of IGBT voltage modification method

Nov , 03 2023

Unlike the resistance method, the voltage method involves changing the driving voltage during the control phase to control voltage and current overshoot. There are approximately two methods to change the driving voltage. One is to achieve the change by dividing the driving voltage through a resistor, and the other is to change the output signal in the control chip (DSPFPGA), and then convert it in...

more

Comparison of advantages and disadvantages of various energy storage systems

Nov , 16 2023

Comparison of advantages and disadvantages of various energy storage systems 1, mechanical energy storage Mechanical energy storage mainly includes pumped storage, compressed air energy storage and flywheel energy storage. (1) Pumped storage: when the grid trough the use of excess electricity as liquid energy media water from the low-lying reservoir to the high-lying reservoir, the grid peak load ...

more

Lead-acid battery failure model

May , 11 2024

The most common failure modes are: - Softening or shedding of the active material. During discharge the lead oxide (PbO2) of the positive plate is transformed into lead sulfate (PbSO4), and back to lead oxide during charging. Frequent cycling will reduce cohesion of the positive plate material due to the higher volume of lead sulfate compared to lead oxide. Corrosion...

more