everexceed high rate solutions

How to charge Lead Acid Battery properly?

Aug , 31 2021

A battery is an electrochemical device. During the battery discharge process, the stored chemical energy is converted to electrical energy that is used to power an electrical load. The charging process is the opposite reaction, where the electrical energy from the charging source is being stored into the chemical energy of the battery. In this article, we will know about the procedures of charging...

more

The basics of Solar Panel

Aug , 31 2021

What are solar panels made of and how do they work? Solar cells are made primarily from silicon, a chemical element with conductive properties. Exposure to light changes silicon’s electrical characteristics, which generates an electric current. A cell is a small square of silicon (about 6” x 6” or 5" x 5") with electrical contact plates on the face. Solar panels are made by laying out a grid of th...

more

Developing an Energy Management Strategy (EMS) for LiFePO4 based ESS

Aug , 31 2021

Working closely to setup large-scale Lithium battery based Energy Storage System (ESS) for a wide variety of main grid, weak grid and micro grid installations; EverExceed has significant experience and insight on the real-world operation and optimization of energy storage technology. The most important consideration for any ESS is to view it as part of a whole system rather than as a sta...

more

How to implement battery monitoring in a deployable product?

Nov , 27 2021

Standalone ohmic battery monitoring systems designed for data center application are not suited for a genset environment. Although ohmic monitors work, they are expensive (estimated at $2,000 for a 24-volt system), time-consuming to install, and require trained personnel to interpret their data output. To achieve widespread adoption in the genset market any battery monitoring technology will need ...

more

What are the recharge cycles phases of a Lead acid battery?

Nov , 27 2021

The fastest generally accepted way to charge a conventional (lead‐acid or NiCd) battery is with a constant voltage, a current limited battery charger that is capable of both “boost” and “float” output voltages. “Boost” charging applies a higher than normal voltage to the battery early in the charge cycle to charge the battery as quickly as possible. Later, once the battery is charged, charging vol...

more

Some common question answers for Portable Energy storage solutions

Dec , 24 2021

As a leading energy storage solutions provider, we always get asked a varieties of questions by our valuable customers and partners, here in this article we have accumulated a few of them and tried to answer them accordingly. How long can I use my portable power storage to power my devices? First, you need to check out your device's operating power (measured by watts). If it is less than the outpu...

more

What is Thermal runaway and what is its impact on cell chemistry?

Jan , 06 2022

One of the main causes of danger for lithium-ion cells is related to the phenomenon of thermal runaway. This is a healing reaction of the battery in use, caused by the nature of the materials used in the chemistry of the battery. Thermal runaway is mainly caused by the solicitation of batteries under specific conditions, such as overload under adverse climatic conditions. The result of a thermal r...

more

Three Big Reasons You Should Pair a Home Battery with Solar

Jan , 10 2022

As residential solar installations increase across the country, homeowners are realizing that investing in solar alone won’t benefit them in the long run. The reason is because most solar energy is produced between 9 a.m. and 3 p.m. while (pre COVID-19) you’re probably at work or school. When you return home and start using your electronics and appliances, it’s likely that there isn't enough solar...

more

3 Reasons to Choose Energy Storage over a Generator during Fire & Hurricane Season: Reason-3

Jan , 10 2022

Past 2 years will stand out in the history books as years that forced us to radically rethink (and adjust) the status quo. As we go into summer, the stability of our utility grid will be put to the test when many of us are spending most of our time at home. Fire season will begin shortly in different places, with utilities sending out messages about public safety power shutoffs. On the...

more

How to do the SOC-OCV test for Lithium batteries?

Apr , 06 2022

OCV is very important for SOC estimation. It is a function of cell SOC and temperature. There are two methods to measure the OCV, namely coulomb titration and voltage relaxation. The former discharges and charges the cell with the same low current while measuring the terminal voltage. The OCV is defined as the average value of the charge and the discharge terminal voltage. The latter determines th...

more

High Frequency / High Ripple Resonant Chargers: Good or Bad? (part-1)

Jun , 13 2022

Battery charging is a complex electrochemical process, in which the discharged electric energy is replenished from the electric power grid. This is accomplished using a battery charger, which is an electrical/electronic device that converts the incoming AC line voltage into a regulated DC voltage to meet the charging needs of the respective battery. In a series of articles we are going to explain ...

more

High Frequency / High Ripple Resonant Chargers: Good or Bad? (part-2)

Jun , 13 2022

Battery charging is a complex electrochemical process, in which the discharged electric energy is replenished from the electric power grid. This is accomplished using a battery charger, which is an electrical/electronic device that converts the incoming AC line voltage into a regulated DC voltage to meet the charging needs of the respective battery. In a series of articles we are going to explain ...

more

what are you looking for?

blog

blog