China DC Rectifier and Battery System,Competitive Price DC Rectifier and Battery System

Measures to suppress harmonics

May , 11 2024

The fundamental cause of harmonic generation is due to nonlinear loads. When the current flows through the load and does not have a linear relationship with the applied voltage, it forms a non sinusoidal current, resulting in harmonics. The suppression of harmonics in the power system is to reduce or eliminate the harmonic current injected into the system, in order to control the harmonic voltage ...

more

The difference and comparison of advantages between P-type and N-type components

May , 11 2024

Materials and Structure of a Solar Cell The construction of a particular solar cell is going to vary slightly depending on the specific technology that is utilized to manufacture it. In most solar cells, there is an aluminum back surface field and a P-N Junction. At the P-N junction, there are p-type crystalline silicon wafers that are positively charged and n-type crystalline silicon wafers that ...

more

Inverter common fault contents and solutions

May , 11 2024

As an important component of the entire power plant, inverters can detect almost all power plant parameters for both DC components and grid connected equipment. If there is an abnormality, the health status of the supporting equipment in the power station can be checked through the feedback information from the inverter. Below are some common fault information and handling methods for photovoltaic...

more

Differences in communication serial ports

May , 16 2024

RS-232 and RS-485 are two common serial communication standards, with the following main differences between them: Different transmission methods: RS-232 adopts a single end transmission method, and its data signal is relative to the signal ground, usually used for point-to-point communication; RS-485 adopts differential transmission mode, allowing multiple transceivers to be connected on the bus,...

more

A Brief Introduction To Filter Circuits

May , 25 2024

In the rectifier filter circuit, there are two parts of the circuit altogether, respectively the rectifier circuit and the filter circuit, the functions of the two are different, the function of the rectifier circuit is to convert the sine wave AC voltage, and the function of the filter circuit is to convert the unidirectional ripple voltage, and the functions of the two parts of the circuit work ...

more

What is a nickel-cadmium battery

May , 31 2024

1. Working principle of nickel-cadmium battery Nickel-cadmium batteries are rechargeable batteries that convert chemical energy into electricity through REDOX reactions. It consists of a negative electrode (the negative material is Cd), a positive electrode (the positive material is NiOOH), and an electrolyte (the main component is KOH). 2. Features of nickel-cadmium batteries Long cycle life; Wid...

more

Methods for reducing ripple voltage

Jun , 06 2024

Brief introduction Ripple voltage is a voltage fluctuation in the output of a DC power supply, referring to the AC component of the output voltage. Excessive ripple voltage can have an impact on the normal operation of electronic devices, so reducing ripple voltage is an important issue that needs to be addressed in the power supply design process. This article will introduce some commonly used me...

more

Air cooling and heat dissipation design of industrial and commercial energy storage system

Jun , 14 2024

1 Air cooling and heat dissipation design of industrial and commercial energy storage system Air cooling is the use of air as a heat exchange medium, the use of air to circulate in the battery pack, the use of the temperature difference between the battery module and the air for heat transfer, generally divided into passive air cooling and active air cooling. The main factors affecting its cooling...

more

Industrial and commercial energy storage system liquid cooling design

Jun , 14 2024

1. Industrial and commercial energy storage system liquid cooling design For the high-rate charging and discharging process of large-scale battery packs, the cooling capacity of air cooling system can not meet the heat dissipation demand of battery packs. Liquid has a higher specific heat capacity and higher thermal conductivity than air, and the liquid cooling cooling speed is faster, which has a...

more

Maximum power point tracking algorithm for photovoltaic power generation

Jun , 22 2024

1. Introduction Photovoltaic power generation is a technology that uses solar energy to convert light energy into electricity. In the photovoltaic power generation system, in order to obtain the maximum power generation power, it is necessary to track the change of solar radiation intensity in real time, and adjust the working state of the photovoltaic module to keep near the maximum power point. ...

more

Five things that shorten the life of your UPS battery

Jun , 26 2024

One of the more common questions we get asked is how long a UPS battery will last. The ballpark, general answer is 3 to 5 years; however that answer is generallyl. And that’s because the life of your battery depends on a whole host of factors. Those factors are what we’re going to discuss today. Here are some of the things that can shorten the lifespan of your UPS battery. Let’s jump right in. Amb...

more

Influence of lithium analysis on battery capacity

Jun , 27 2024

I. Introduction The phenomenon of lithium evolution is an important problem affecting the capacity of lithium batteries. This article will discuss the impact of lithium analysis on battery capacity with you in detail, and analyze its causes and solutions. Second, the impact of lithium on battery capacity 1. Loss of active lithium ions Lithium evolution causes some of the lithium ions to form lithi...

more

what are you looking for?

blog

blog